Jump to content


  • Content Count

  • Joined

  • Last visited

  1. It depends on solver convergence if model can converge at 1e-3 then specifying hmax=1e-3 is sufficient to make solver to take this fixed step. Solver always attempt smaller step sizes irrespective of hmin & hmax to find convergence during trasient simulation.
  2. Hi, Is your HW suit is a Server installation? I have seen few quiries similar with server installed HW. Cheers, Reddt
  3. Hi, Select macros>create point between points now, from panel area select radio button 'create a point at center of circle' Cheers, Reddt
  4. Hi Siva, I would like to know what is the integrator type your are using? By default it would be "DSTIFF", try changing it to "VSTIFF". Cheers, Reddt
  • Create New...