Jump to content

Jaimit Gandhi

Members
  • Content Count

    4
  • Joined

  • Last visited

About Jaimit Gandhi

  • Rank
    Newbie

Profile Information

  • Gender
    Male
  • Country
    United States
  • Interests
    Finite Element Analysis - Product Development
  • Are you University user?
    No
  1. I have run Nastan Sol400 calculation. However I am unable to load .dat model and .op2 files in HyperView. Nastran input deck was created using Beta CAE ANSA but this shouldn't be the issue. I am also able to pull out the model and result in Beta CAE Meta. Any suggestions?
  2. Thank You tinh. This would work.
  3. I am creating MSC Nastran input deck using HyperMesh. I have the model where I want to apply multiple loads in steps. Step-1 Bolt Preload Step-2 External Force on model holding the preload applied in Step1 Step-3 No load at all but bolt preload If I create different loadsteps from Utility, it seems they are going under different subcases, and in such scenario the loads would not be dependent. Each subcase would be treated as different simulation, wouldn't it? So my question is how do I create sequential steps? The .dat file should look like below. Sol 400 CEND STRAIN(PLOT)=ALL STRESS(PLOT)=ALL DISPLACEMENT(PLOT)=ALL FORCE(PLOT)=ALL ANALYSIS = NLSTATICS NLSTEP = 1 STEP 1 SPC = 1 LOAD = 1 STEP 2 SPC = 2 Load = 2 STEP 3 SPC = 2 BEGIN BULK $----------------------------------------------------------$
  4. Hi Rahul, I am using HyperMesh and Optristruct. My problem is 2D. I want to apply enforced displacement. As per your suggestion, I have created two load collectors. SPC for constraining DoF (in my case x or 1 and y or 2 unmarked) for all nodes. Another load collector SPC with load type SPCD and respective displacements. Now in my loadstep how do I use these two load collectors? As per the menu in HyperMesh, I can only choose one SPC, where do I put another load collector (SPCD)? Please correct me if I am wrong somewhere.
×
×
  • Create New...