Jump to content


  • Content Count

  • Joined

  • Last visited

About Frehab

  • Rank

Profile Information

  • Are you University user?

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Alex, It has been a while since you asked that question. I don't know if you still need help. If you do, please check Analysis -> Preserve nodes see if there are any preserve nodes in your model. HM would automatically delete those once you transfer any preserve nodes to normal nodes.
  2. @Prakash Pagadala Thanks, please post it here when you found it
  3. Hello, I am doing a NVH optimization and facing a problem when setting the frequency response. As asked by the Optistruct, i need a specific mode number for response setting. However, it is just a topology optimization which still in the very beginning of concept design. I do not know which mode is the one I need. For the EIGRL, I picked from 1 to 60 hz with 10 exporting mode. So my question is which mode should I leave to the response?
  4. Hello, Could any one show me how to extract or check the output matrix results after calculation? Thanks
  5. @Prakash Pagadala I changed it to analysis only later. It works now. Yes, you are right. Optimization is too big to run. This model contains about 3 million elements. Thanks again
  6. Hello, Does anyone know where can I download macros shown in this link: http://www.altairhyperworks.com/html/en-US/rl/nvh-webinar-opt.htm If I cannot download them, could someone please tell me how to create them? any tutorial or manual would be appreciated!! Thanks
  7. @Prakash Pagadala Sorry, I am not allowed to share the model. But here is how I set it:
  8. @Prakash Pagadala One more question about the AMSES. After creating the eigra and the cms in the load collector, is there any other operation need to take before set it to run? I have my program on running for 9 hours...it doesn't seems right to me.....
  9. I have found the answer. The ALMS do need extra license to run.
  10. @Prakash Pagadala Yes, i would like to know more about SOLVTYP and how to change the solver method.
  11. Hi everyone, I am trying to setup a NVH problem with AMSES solver. According to altair's solver introduction (http://www.altairhyperworks.com/hwhelp/Altair/hw14.0/help/hwsolvers/hwsolvers.htm?solvers_overview_intro.htm#amses). AMSES should be activated from CMSMETH. I am new to Optistruct. Could some one please explain how exactly the CMSMETH should be set up? And why CMSMETH represents in load collector instead of control card? How about SOLVTYP? please explain how to set up SOLVTYP as well, if may. Thanks
  12. Does ALMS is an out source solver that requires extra purchasing?
  13. Hi, I am wondering that does the Optistruct is a mesh independent optimize solver? in other words, does the topo optimization result in Optistruct change with mesh refinement? I don't have time to make a model for verification so hopefully someone can help me on this. It should not have different pattern of topo optimization for finer elements if proper sensitivity filter used. Thanks,
  14. Hi @Prakash Pagadala Thanks for the reply. I DO have checked this tutorial. Is does solve my problem because: 1. it is shape optimization not topo. Not sure if HS can do topo multi-objective optimization as while. 2. it is linear and didn't mention anything about nonlinear. Do you know if HS do have non-linear optimization feature.
  • Create New...