Jump to content

GA_Peach0511

Members
  • Content Count

    6
  • Joined

  • Last visited

About GA_Peach0511

  • Rank
    Newbie

Profile Information

  • Country
    United States
  • Are you University user?
    Yes
  1. I understand how to call the tcl script from the command prompt. My question is regarding writing those specific commands in the tcl script. Which are basically. 1. Load the results and model 2. deform model 3. output model for use in hypermesh
  2. Hello, I am trying to write a tcl script for HyperView to run in batch mode. I need to load my model and results. Apply the results to the final increment and then export the model in a TCL script. None of the hypermesh commands are working and I cannot find HyperView TCL commands. Can anyone explain how this is done?
  3. I️ have tried it without the Pcont cards only using slide contact. It will run just still no convergence. Is Optistruct not able to handle the model? I’m thinking I️ may need to use another solver
  4. Hi, I have a model of a breast that should be deformed between two plates. I have tried various variations using the PCONT card, CNTSTB, and EXPERTNL with CNTSTB and I still cannot get the model to produce results. I have tried increasing the NINC card as well to not avail. The top plate will move but it is not interacting with the breast to have it spread across the bottom plate. Any help would be greatly appreciated.
  5. I receive the below error when I try to run my tcl script in hmbatch mode. This same script however will run when I run it inside of Hypermesh using the scripting toolbar and gets no errors. I would like to run this in batchmode. ======Shell AR Distribution: max=3.91===== [AR=1~1.5]: et cnt=200 [AR=1.5~2.25]: et cnt=552 [AR=2.25~3.38]: et cnt=35 [AR=3.38~5.06]: el cnt=1 8 #0 star shape failed at enclosed stage Any suggestions? I have attached the tcl script. Base_shrinkWrap.tcl
×
×
  • Create New...