Jump to content

pmanock

Members
  • Content Count

    2
  • Joined

  • Last visited

About pmanock

  • Rank
    Newbie

Profile Information

  • Country
    United Kingdom
  • Are you University user?
    No
  1. Hi All Trying to run an Optistruct analysis to see how two layers of different materials will displace when experiencing a thermal load. In my case I have chosen points along a lattic where the temperature would be 80degC. But when running my model in Optistruct and in trying to view the results, the model cannot show a viable solution or a solution that makes sense, in fact, I have not setup the pre processing properly (it seems) which has lead to a model with massive deformation. Also I am unable to view the contours. The attached picture shows circled areas (red) where I have made equivalence nodes, there is an expected connection at these points (not defined). Hoping that anyone could give advice or guidance! Phil Busbar Copper Lattice Model 2D.fem Busbar Copper Lattice Model 2D.mvw
×
×
  • Create New...