Jump to content

Dung the most handsome man

Members
  • Content Count

    22
  • Joined

  • Last visited

1 Follower

About Dung the most handsome man

  • Rank
    Beginner

Profile Information

  • Country
    Vietnam
  • Are you University user?
    Yes

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi everyone, Currently, i'm doing an exercise which is related to u-bolt connector (describe in the picture below). And i don't know how to model this connector in hypermesh. Thanks for your help.
  2. Hello, I did a tutorial in Inspire cast, the porosity result has shown the areas that the ratio of voids to solid areas is greater or equal than to the specified value. And i don't know how to measure the size of the porosity of each value. So, how can i measure the size? Thanks.
  3. Hello, Thanks for your answer. I read this post: Mr. Rahul said that stl should be used as a template / guide to create solid geometry within Inspire. If the model looks easy to rebuild it manually, it's ok, but if the stl model is complex, what should i do to create the solid geometry? Thanks.
  4. Hi, I have read the c2c getting started document, it even uses stl file directly after import it into the software. Like this post: In inspire cast, i don't know how can it set up the condition if i only have stl model. Thanks.
  5. Hello everyone, I have a problem when import stl file into inspire cast. When i set up the problem, the 'open window' show up like this And i can't set up the condition of the problem. Thanks.
  6. Hello everyone, I'm newbie in Inspire. When i imported the stl file into inspire, i couldn't analysis. After reading an answer of a similar question in our forum, i figured it out that i have to create solid geom from stl file. But the question is how do i know if the solid model can be created automatically from stl file, or i have to do it on my own. Thanks.
  7. Hi, Thanks for your answer. And i have another question about the porosity size, how to measure the porosity size in ST inspire cast? Thanks.
  8. Hi everyone, After simulating a problem, i have porosity result, so how do i know if the porosity is acceptable? I have referred some standard like ASTM E155 and it only shows radiographs standard for casting. Thanks.
  9. Hi, When i used Inspire cast 2019, it took too much time to solve the problem, but when i used v2018.3, it took 15 minutes to solve this problem. And i assure that i set up the problem exactly like the tutorial. Thanks.
  10. Hi everyone, I have a problem when meshing a model. It's a simple model, i adjust the mesh size but it still happen. Thanks.
  11. Hi Everyone, I have a problem when meshing a model, this panel show up. I have adjusted the mesh size but it still happens. Thanks.
  12. Hello Matthieu, Here is the tutorial that i'm doing It takes about 6 hours but has not completed yet although I did exactly steps and filled accurately parameters in the tutorial. Thanks.
×
×
  • Create New...