Jump to content

Denis Krebelj

Members
  • Content Count

    1
  • Joined

  • Last visited

About Denis Krebelj

  • Rank
    Newbie

Profile Information

  • Country
    Slovenia
  • Are you University user?
    No
  1. Hello. I would like to run a linear static load in optistruct solver, by using strain output from Moldflow analysis. Initial strain is available in following form (Nastran format); " $ OUTPUT PRODUCED BY MOLDFLOW PLASTICS INSIGHT $ $-------2-------3-------4-------5-------6-------7-------8-------9-------0------- STRAIN,1,1,2.931-3,1.352-2,0.000,0.000,0.000,0.000,+S1 +S1,0.000,0.000,2.931-3,1.352-2,0.000,0.000,0.000,0.000,+S2 +S2,0.000,0.000,2.931-3,1.352-2,0.000,0.000,0.000,0.000,+S3 +S3,0.000,0.000,2.931-3,1.352-2,0.000,0.000,0.000,0.000,+S4 +S4,0.000,0.000,2.931-3,1.352-2,0.000,0.000,0.000,0.000,+S5 +S5,0.000,0.000,2.931-3,1.352-2,0.000,0.000,0.000,0.000,+S6 +S6,0.000,0.000 STRAIN,1,2,1.060-2,5.582-3,4.536-3,0.000,0.000,0.000,+S1 +S1,0.000,0.000,1.060-2,5.582-3,4.536-3,0.000,0.000,0.000,+S2 +S2,0.000,0.000,1.060-2,5.582-3,4.536-3,0.000,0.000,0.000,+S3 +S3,0.000,0.000,1.060-2,5.582-3,4.536-3,0.000,0.000,0.000,+S4 +S4,0.000,0.000,1.060-2,5.582-3,4.536-3,0.000,0.000,0.000,+S5 +S5,0.000,0.000,1.060-2,5.582-3,4.536-3,0.000,0.000,0.000,+S6 +S6,0.000,0.000 " Material tipe is MAT8. I can't find a way to write initial strain or stress state to optistruct input. Regards.
×
×
  • Create New...