Jump to content

Jakebrake1

Members
  • Content Count

    7
  • Joined

  • Last visited

About Jakebrake1

  • Rank
    Newbie

Profile Information

  • Are you University user?
    No

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Dear Sirs, I'm new on the RISC processors, I observed that solidThinking Embed is capable to program Arduino based MCU's, then Is it possible to utilize the solidThinking Embed for programming the ESP32 hardware? I got the ESP-Wrover-Kit and I would love to handle it thru sTE Thank you for your time.
  2. Oh!...yes, you're right!! And seems that the phase and enable pins are available tho~ Whish to have more changeable options like dead band and the action qualifier... Thank you a lot
  3. Hello! I created an SWPM generator for 3-phase (as well for single-phase). And after seeing the examples in the simulation about the VCM-SPWM 3-phase block with all the configurable features (3rd harmonic injection, carrier waveform, minimum pulse width, etc.) I wonder: Is it possible to add variables that can be called outside the Codegen block? What I mean is, in the ePWMx block there are several configurable options but all must be configured previously, it cannot be modified "on the run"; just for example, if I want to change the rising edge, I have to stop the process, enter to the block, modify it and run the whole setup again. I tried to put literals on those options but it generates the error of "Please enter a positive integer." Some ideas? Thank you for your time.
  4. Hello! Thank you for your answer. I solved the issue after a long night. The problem was that in the look-up table block and the modulator block both had the Execute interrupt enabled (even with different EPWMs). Just removed one and all worked fine. Thank you
  5. Dear Sirs, I'm again writing to you for some guidance on this matter. According to the doc file Digital Power150UG, in chapter 3; there is a controller that I want to utilize directly in my 28377S (specifically Digital Power/ Simulation/ Controllers/ VCM-SPWM 3-phase ). After I lasso the block and tried to perform Code Gen I get the following: Code generation disabled for compound SPWM (3-phase). I assume this happens due to I'm in the Simulation section, but the rest of the sections don't have that block (and I don't need the SPWM realization - 3-phase...under Examples/Codegen/PWM). There are particular steps to utilize and implement this block that I'm not aware? Or how can I enable the code generation for this compound? Thank you for your time.
  6. Hello! I'm a kind of newbie in this. I just created for the LAUNCHXL-F28377S a simple application to be controlled by Texas' GUI. However, after generating the code and trying to build it in CCS v8 I got the following: >> Compilation failure subdir_rules.mk:9: recipe for target 'main.obj' failed "../main.c", line 6: fatal error #1965: cannot open source file "cgen.h" 1 catastrophic error detected in the compilation of "../main.c". Compilation terminated. gmake: *** [main.obj] Error 1 gmake: Target 'all' not remade because of errors. **** Build Finished **** The same goes for c2000.h... Some ideas how to overcome this? Thank you. Blinking_LEDS.c
  7. Hello! I'm a newbie in this software, I've been trying to create 3-phase PWM (120 deg) using TBPHS. The first and second phases are straightforward but the third one collapses beyond 66% duty. I cannot make it synchronize the third phase with the second one. Some suggestions? Thank you for your time. PS.- This is not sinusoidal waveforms, just square ones.
×
×
  • Create New...