Jump to content

mramakri

Members
  • Content Count

    12
  • Joined

  • Last visited

About mramakri

  • Rank
    Beginner

Profile Information

  • Gender
    Male
  • Country
    United States
  • Are you University user?
    Yes

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi @Premanand Suryavanshi There is no change. Are you able to view the elements in your computer?
  2. Hi @Premanand Suryavanshi It still does not show the elements.
  3. The results for an analysis with MAT1 (Linear elastic only) card and another with MATS1 (Non Linear using TABLES1 card) subcase is showing the same results. The load applied should make the part undergo plastic deformation when MATS1 is used but this is not observed in the results. C1C1R_0.1.hm
  4. Hello A section of elements in a component are not being displayed when I look at the result files in Hyperview. I have tried moving elements to a new component, but the results is the same as seen below This is for a structural analysis in optistruct. Model: Output:
  5. Thanks @Premanand Suryavanshi How do I relate the x,y,z in result type to the user system. In my case, its cylindrical. Is there a way to figure out the the corelation between x,y,z and r,t,z?
  6. @tinh Hi I am able to create the coordinate system. How do I get the output in the new system? Is the best method to choose axis in hyperview?
  7. Thank you for your help. It works.
  8. Hi Prakash Pagadala, I have sent you the model file.
  9. Can someone help me with the following error? *** INTERNAL PROGRAMMING ERROR *** in file "datasetFtoC.c", at location # 345. C1C2C.out
×
×
  • Create New...