Jump to content

Daniele.70

Members
  • Content Count

    3
  • Joined

  • Last visited

About Daniele.70

  • Rank
    Newbie

Profile Information

  • Country
    Italy
  • Are you University user?
    No
  1. Good evening all, is there any limitation in the number of Pattern Repetition constraints that are applicable in a single Optistruct run? I am trying to run a Composite Free-Size Optimization analysis but the job stops if I enforce more than 4 or 5 constraints of this kinds on designable PCOMPGs, while it runs fine if I reduce the number of the constraints below the named maximum number of 4 or 5. If it is a documented bug, is there any turnaround? Thanks, regards. Dan
  2. Good morning gents, I am running two jobs in Optistruct (A and B, the only difference between the two consisting in the fact that in A the model is built with full node and element components, in B some portions have been replaced with their counterparts in reduced form (equivalent mass and stiffness matrices reduced to the interface points). The reduced models have been created with a GUYAN reduction (CMSMETH ,1000,GUYAN) in .h3d format and read with the proper ASSIGN statement. The jobs are static analyses with inertia relief. The problem that I have is that unexpectedly the results of B differ from results of A, not much but by a decent amount. Is this normal? Is there any particular attention that I have to pay when I create the reduced models or when I read them into the assembled structure? Thank you, cheers. Dan
  3. Good morning gents, I am running two jobs in Optistruct (A and B, the only difference between the two consisting in the fact that in A the model is built with full node and element components, in B some portions have been replaced with their counterparts in reduced form (equivalent mass and stiffness matrices reduced to the interface points). The reduced models have been created with a GUYAN reduction (CMSMETH ,1000,GUYAN) in .h3d format and read with the proper ASSIGN statement. The jobs are static analyses with inertia relief. The problem that I have is that unexpectedly the results of B differ from results of A, not much but by a decent amount. Is this normal? Is there any particular attention that I have to pay when I create the reduced models or when I read them into the assembled structure? Thank you, cheers. Dan
×
×
  • Create New...