Jump to content

cgmacca

Members
  • Content Count

    6
  • Joined

  • Last visited

  1. I have run an analysis on a model with fasteners. I can get callouts for stress, reaction forces at support etc but how do I get the tension and shear force on the fastener connections? Inspire 2017.2.1 Regards, Clayton
  2. Ok I have had a little play with this and found a few things. When I tried this on a model that had only supports and forced displacement, after running the analysis I only got displacement results (no stress results) and mousing over with the callout gave a displacement not a reaction. If I then added a very small force and ran the analysis the results showed all the stress results as well as displacement and mousing over the forced displacement gave a reaction force. Another thing, is it possible to get the load in a fastener connection? Thanks, Clayton
  3. Is it possible to find out what the reaction loads are at the supports of a model after doing an analysis?
  4. I have two related selection questions: 1) I would like to select the bottom face to pull of the plate in the attached picture ("select_other_side.jpg" top face is selected) without having to rotate the view to look from the underside. Is there a way to cycle through selections to pick the entity I want? 2) After creating a sketch ("sketch.jpg" attached) on an existing plate and using the plate curves to create a new part I would like to pull these curves to extrude but when I go to select to pull the original plate face is selected and not the new face created, is there a way to cycle through selections to pick the entity I want? Regards, Clayton
×
×
  • Create New...