Jump to content

Nick1535394412

Members
  • Content Count

    3
  • Joined

  • Last visited

About Nick1535394412

  • Rank
    Newbie

Profile Information

  • Country
    Australia
  • Are you University user?
    No
  1. In v2019.2 analysis of optimization via shape explorer doesn't list results of load cases in Compare Results table it only shows the design load case (the element density run) any ideas?
  2. Trying to bring a .fem model from Optistruct into Inspire but it keeps converting it to mm. So whereas the model is 1.5in long in Optistruct, Inspire makes it 1.5mm long. Changing the working units doesn't seem to alter this behaviour, so I'm stumped for now. Cheers
  3. Slide the slider all the way back just before the optimization starts to disintegrate. Rule of thumb is to make sure the optimization is fully converged (connected, no disintegration). Notice the mass of the solution decrease as you slide back. This however does not mean that the results are necessarily the "optimal" solution. Run analysis on it and check the animation as well as max displacement etc for a cursory sanity check. Remember, crap in = crap out, so the more quality information (realistic load cases, model not over constrained etc.) the more likely you are to get optimal results.
×
×
  • Create New...