Jump to content

MUHAMMAD ADDHAM MOHD AINI

Members
  • Content Count

    3
  • Joined

  • Last visited

About MUHAMMAD ADDHAM MOHD AINI

  • Rank
    Newbie

Profile Information

  • Country
    Malaysia
  • Are you University user?
    Yes
  1. Thanks mate for feedback I will do it to enhance no of nodes. I will show to you the result later.
  2. Regarding on above solution that your advice me to change I was did it: 1. the mesh element no increase from 109,000 to 115858 nodes 2. max stagger iterations I put it into 4 3. For this one, I did not confirm it. From what I know two to five degrees of rotation per time step is for sliding mesh method. FYI, the simulation was finished after a couple of days but my concern here the validation on that what I run in experimental and simulation analysis give the results a quite bigger gap. As an example, I want to know the rpm of the wind turbine. In the experiment, the rpm is 207 and the simulation the rpm is 92. Btw, thanks in advance for your response acupro. blade.inp blade.1.rar
  3. Dear all, I have to do CFD Analysis (Rigid Body Dynamics) of a Wind turbine rotation, and I have just come across this error message when running an AcuSolve simulation. Attached herewith is my complete file for .Log and .inp does anyone know about for this error? Thanks in advance Best Regards, Addham blade.1.Log blade.inp
×
×
  • Create New...