Jump to content

Laura27

Members
  • Content Count

    6
  • Joined

  • Last visited

About Laura27

  • Rank
    Newbie

Profile Information

  • Country
    Italy
  • Are you University user?
    Yes

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hi, I have to simulate the kinematics of the line trasmission of the primary flight controls and I have many problems in choosing joints. In this line, motion is given to elements circled in blue in the picture below. In the picture, green lines define the motion, while nodes red circled are points where I have to insert joints. Elements need to rotate around the three axis, but rotation around axis off element's plane is limited (8°). Moreover, in elements with three points, the point in the middle is fixed and only rotation is possible. I tried to insert in those points revolute joints and in other points I tried ball joints but I didn't know how to limitate rotation up to 8° so I tried many joints but with poor results. Consequently, I would like to ask you which joints could be good in the elements in the picture. I thank you in advance.
  2. Hi, I would like to know how I can detect interferences and penetrations between bodies as I would like to stop the simulation when this happens. I tried to use "Collision Detections" but nothing has changed. I thank you in advance. Best regards.
  3. Dear Team, I have to import models from Solidworks and to simulate the kinematics of the line trasmission of the primary flight controls. I would like to know how I can fix components. In fact, as is it possible to see in the picture, the element circled in blue on the left don't follow other elements in the simulation on the right in the picture and it is detached. In other elements I faced the same issue and I fixed them with a fixed joint, but in that point there is already a revolute joint between the yellow element and the blue element. Consequently, I am wondering if there is a faster way to fix components to each other rather than insert many fixed joints. I apologize for the trivial question, but I am a beginner. I hope you can help me and I thank you in advance.
  4. Dear Team, for my thesis I have to import models from Solidworks and to assemble them in order to simulate the kinematics of the line trasmission of the primary flight controls. I would like to know how I can assemble models imported in MotionView, as when I import models I can't move them to the right position. I looked for examples, but I didn't find them, so that I ask you if there are tutorials for my case. I apologize for the trivial question, but I am a beginner. I hope you can help me and I thank you in advance.
×
×
  • Create New...