Jump to content


  • Content Count

  • Joined

  • Last visited

About tudormasalar

  • Rank

Profile Information

  • Are you University user?

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hello, I just got into Altair Embed and I have encountered a problem. Whenever I try to download the already generated and compiled code into my Launchxl-F28069M it sais "Target open failed: check config for correct target number". I will post a picture below with my config and model. Even a little hint would be appreciated! Oh and also, I need to mention that I have all SW1 set to ON to enable JTAG comms. Thanks in advance for everything! Quick edit: I just tried to run this model in interactive mode, and got an error that said something about there being no JTAG communication. How can I make sure I have a solid communication? (via USB). The error was: Can't open target. Check: 1. Power to target 2. JTAG connection 3.JTAG driver selection in target config
  • Create New...