Jump to content

Sankalp_Patil

Members
  • Content Count

    3
  • Joined

  • Last visited

About Sankalp_Patil

  • Rank
    Newbie

Profile Information

  • Country
    Germany
  • Are you University user?
    Yes

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Hello, I would like to have a node numbering in a prescribed order. Requirement - Nodenumber sequence from top to bottom and follwing the same from left to right in the X-Y plane. This works well as shown in the figure. The requirement is to witness the same numbering order in all the X-Y planes along Z axis. The drag option along Z axis is used to create 3D elements. I dont achieve the node numbering in the same order as that on the 2d plane. The node numbers skip and have no sequential order as shown in the figure below. The renumber option available did not turn out to be of much help. Any sorts of suggestions or help is appreciated. Thanks, Sankalp
  2. Hello, The Topology Optimization in Optistruct by default uses the Direct method for the Sensitivity analysis. I am predicting the result variation using the Adjoint method. It would be of great help to me if I know the way that I can make the solver use the Adjoint method of Sensitivity anslysis. Any help is appreciated! Thanks!
  3. Hello Erica, i met with the same situation during Topology Optimization and was curious to know if you were able to find the solution for the same. If so, it could be of great help if you could share the same. Thanks!
×
×
  • Create New...