Jump to content

Jasmin Heyser

Members
  • Content Count

    4
  • Joined

  • Last visited

About Jasmin Heyser

  • Rank
    Newbie

Profile Information

  • Are you University user?
    Yes
  1. The cosimulation does't run though. I tried to run the motionsolve model without the cosimultion to make sure that the model is fine. I used curves as Inputs and It worked in pure MS simulation because the curve points are interpolated with cubic polynomials that can form first and second time derivatives. However the convergence problem is still there. Could it be that the problem is caused by the use of Angle sizes as Plant_Inputs for which no derivation information is available? Jasmin
  2. Hi Chris, I checked that the MotionSolve model solves without the cosimulation and the tutorials for co-simulation worked fine. Is it possible that the Plant_Input variables of the motions could be the cause? that they can't be differentiated two times? best regards Jasmin
  3. Hello, I am working on a cosimulation between simulink and Motion view/ moton solve right now. But when I start the cosimulation has convergence Problems that where shown in the log file of motion view. I checked the debug mode and found the errors that say that there are problems with the MEX-File and the libraries, there was also written that the icudt61.dll file couln't be used. I searched the web and found in the forum that the .dll file might only be for the 32 bit version of matlab but not for the 64bit (the version I have) here is the link to the forum page I found: https://www.mathworks.com/matlabcentral/answers/488651-need-icudt61-dll-when-using-vlfeat-in-matlab-2019a I wonderd If any body had that problem before, if this could be the reason for the convergence problem and how I could fix it?. thanks in advance and kind regards Jasmin Heyser
  4. Hello, I am working on a cosimulation between simulink and Motion view/ moton solve right now. But when I start the cosimulation has convergence Problems that where shown in the log file of motion view. I checked the debug mode and found the errors that say that there are problems with the MEX-File and the libraries, there was also writen that the icudt61.dll file couln't be used. I searched the web and found in the forum that the .dll file might only be for the 32 bit version of matlab but not for the 64bit (the version I have) here is the link to the forum page I found: https://www.mathworks.com/matlabcentral/answers/488651-need-icudt61-dll-when-using-vlfeat-in-matlab-2019a I wonderd If any body had that problem before, ich this could be the reason for the convergence problem and how I could fix it. thanks in advance and kind regards Jasmin Heyser
×
×
  • Create New...