Search the Community
Showing results for tags 'auto'.
Found 3 results
Hi everyone, I have problem obtaining the TCL command of auto contact pair finding. My model contains 6 components, I use the Abaqus contact manager to automatically find contact pairs for me. Manually, I can successfully find contact pairs. Since I want to run this process automatically by TCL script, I do the process manually and check out the code added in the command.cmf file. Unfortunately, the code are very long, approximately 50000 lines. Also, the code are about nodes' data and surface set, which is not I am looking for. I am looking for the command that represents the buttons "auto", "components: all", "find", "create". I will show these buttons in the figures attached. By the way, the file: raw.hm is my model. Again, my goal is to get the TCL code for finding contact pairs. Please help me, thanks! raw.hm
My question is how to use TCL scripts to swap master-slave surface. Like the figure attached, I want to swap master-slave surface of those highlighted contact pairs. I want to use Young's modulus to decide which surface should be master, and the other to be slave. Master surface should have higher Young's modulus. So, how can I write this if statement and swap the master-slave surface? My model is also uploaded, and I have created the contact pairs. But the contact pairs have'nt been swapped. raw.hm
Hi, I've started to use Radioss few days ago, and I'm performing an impact analysis on a vehicle component. Actually I'm not able to find the Autocontact tool (as in Hypermesh Optistruct) in order to set all the contact surfaces. Can you tell me where could I find it please? Thanks in advance