Search the Community
Showing results for tags 'bulk data'.
Found 3 results
I came across in the documentation that the life is calculated using the formula. Sr = SRI1(Nf)b But, even after maintaining the co-efficients, TRTMENT, FINISH and [KF] as 1, the results are off (when compared with the manual calculation using the above mentioned formula) by a random factor (approximately 0.5), for each unique component I take for fatigue analysis (Refer image attached). Why is it so? What is the calculation happening at the back end of the software? Why is the factor 0.5 coming into play?
Guest posted a topic in Altair OptiStructDear Prakash, I am trying to do Pressfit simulation in Optistruct with NLSTAT having Dummy Load, SPC & NLPARM I am getting following error : *** ERROR # 1908 *** Case Control data LOAD=1 is not referenced by any bulk data relevant for used subcase type. LOAD = 1 which is dummy load collector is referenced in Load step, then also getting this error. Please address how to fix this issue. Thanks & Regards, Suraj
Hello everyone, I've just tried to use HyperMesh 12.0 but I have some problem. I didn't find the Bulk Data in Radioss on User Profiles panel. There are Block120 , 110 100 ,90 ,51, 44 ,42 and Fix41 but no ''Bulk Data'' so I can't run my work. Thank you in advance.