Search the Community
Showing results for tags 'constant radius'.
Found 3 results
-
I'm carrying out a constant radius analysis and have changed the hard points only, given the following input for the analysis the errors that I'm getting is ERROR: At time=1.401E-08 the integrator failed to proceed. ----------- Possible Causes ----------------------------------------------------- (1) The integration has become unstable. Tighten (decrease) integr_tol, h_max, or both in Param_Transient can help stabilize the integration. If the simulation contains distinctive phases, use multiple Simulate, each with its own proper integrator parameter setting, to selectively tighten the tolerance during the period where instability is encountered. (2) If the simulation was terminated because stepsize has diminished consistently below h_min, reduce h_min in Param_Transient to force integration to continue. (3) Non-physical inertia properties, such as mass=100 Kg and Ixx=Iyy=Izz=1 Kg*mm^2, or extremely small inertia on a part with an unconstrained degree of freedom. Make sure the modeling data, in particular the part inertia and the gravity, are specified in proper units consistent with the units given in Param_Unit element. (4) Beam, flexible body goes out of linear range, bushing has large rotation along more than one axis, curve goes out of its interpolation range, higher-pair joint goes out of the range of U or V, etc. Make sure fundamental modeling assumptions, such as rigid contact assumption used in Force_Contact, are not violated. (5) Motion displacement defined using LINSPL, AKISPL in dynamic analysis, or as a function of model states (DX, VX etc), as well as forces defined as a function of other forces, can cause hard convergence and integrator failure. Avoid these modeling practices wherever possible. --------------------------------------------------------------------------------- ERROR: Abnormal return from transient analysis
- 18 replies
-
- motion view
- motion solve
-
(and 1 more)
Tagged with:
-
I want to simulate different conditions for my full car assembly Can u please provide me with proper tutorials, pdf, webinar or any help.
- 4 replies
-
- road tools
- constant radius
-
(and 1 more)
Tagged with:
-
Hello all, I need some help to solve the next issue in a "constant radius test" in MotionView. Someone knows how to solve this error? Thanks in advance! Checking references and data in System Model Checking references and data in System Misc Checking references and data in System Body Checking references and data in System Rear subframe Checking references and data in System Rear linked solidaxle susp Checking references and data in System Rear shock absorber ( with inline jts ) Checking references and data in System Rear coil spring Checking references and data in System Rear internal jounce bumpers Checking references and data in System Rear internal reb bumpers Checking references and data in System Frnt subframe Checking references and data in System Rackpin steering Checking references and data in System Steering column 1 (not for abaqus) Checking references and data in System Frnt multilink susp Checking references and data in System Frnt shock absorber ( with inline jts ) Checking references and data in System Frnt coil spring Checking references and data in System Frnt internal jounce bumpers Checking references and data in System Frnt internal reb bumpers Checking references and data in System Live axle Checking references and data in System FIALA / HTIRE Checking references and data in System Constant radius analysis 1 Error: Unknown symbol MODEL.sys_tires.o_ms_cp_forces_sae_right_rear.id Error resolving entity Constant radius circling Report-arg6 under Model-Constant radius analysis. Checking references and data in System Output Requests Checking references and data in System Steer controller Checking references and data in System Drive torque controller Finished Checking Model Errors were detected in the model.
- 1 reply
-
- report-arg6
- error
-
(and 1 more)
Tagged with: