Search the Community
Showing results for tags 'convergence issue'.
Found 2 results
Hi, I did induction heating simulation in Flux2D . I try to define my substrates from isotropic to anisotropic on resisitivity - which means the Y-direction value become much smaller. Then I hit the solver but it says the it is not correctly converge. What can I changed to make it happen? Best, Jerome.
Hi All, We are trying to simulate the fluid flow through pump using AcuSolve Multiphase simulation capabilities. Using Sliding Mesh approach, fluid does not enter into the rotating interface zone. Where in case of MRF approach, we are facing convergence issues even for small deltaT.