Search the Community
Showing results for tags 'delay'.
Found 4 results
I am trying to simulate the influence of an unbalanced tyre on the structure using an FRF. Because it is rotating in the XZ-plane I have made two inputs, one excitation in X and one in Z. I combine these inputs in a DLOAD through 2 RLOAD load collectors. The thing I am struggling with is implying a 90 degree phase delay for one of the 2 RLOAD collectors. I have expirimented with the delay option and dphase option but I have not obtained the result I wanted. How do I apply this delay in my model? Is there a tutorial for this?
Submitted by Joe on Tue, 05/11/2010 - 18:22 I am modelling one boiler. The burner will be working at duty or standby mode. However, due to the boiler's design limit, once the boiler goes into standby mode, it can not switch to duty mode within 10 minutes. I wonder how I can add this 10 minutes gap in the model?
Submitted by Joe on Tue, 03/22/2011 - 20:35 I need a 1 microsec output pulse on a GPIO out pin. I will need to set the pin low, delay 1 microsec, then set it high. I know there is a NOP instruction which takes 1 tick. How to I use that?
Hi, After creating a complete model I need to do some tweaking to the polynurbs feature. Due to the use of the trim feature, each update causes my system to hang for up to a minute. Is there a way to suppress the trim features ot to delay their update until my tweaking is done? Thanks!