Search the Community
Showing results for tags 'different'.
Found 3 results
Hi all, I had modeled a steel Plates of two Cases of Same config as shown in fig. Case :1 2D PLATE 2mm Thickness, F=140N(10N/14 Nodes), constraints at opposite end. Case :2 3D hex Plate 2mm Thickness with 2 Layer of Mesh, F=140N(10N/14 Nodes), constraints at opposite end. Clarification required : 1. Both plates are same in Boundary conditions , dimensions and material property. only the element type varies but why the stress induced is different ?
Hello Is it possible to highlight in colour only the lattice structure? I get only one component, which contains the lattice elements as well as the full material. So they both have the same colour. I thank you in advance for your help!
Hi, I am more interested in stress distribution at one location of the model than on some other parts. In the field of interest I would like to make mesh finer compared to other regions of the model. This means that on the shared surface edge I would like to have 2 different element sizes. Could someone tell me how to do this? I am using 2D shell elements with 2D-automesh panel and this tool does not allow to have different element sizes on shared edge. Please also see the attached figure. Thank you.