Search the Community
Showing results for tags 'midsurface mesh'.
Found 2 results
I'm a relatively new user of Hypermesh v12.0 and have run into an issue when trying to use the 2D Automesh on a particular geometry. I am meshing an elliptical cylinder with interior stiffeners, i.e., frames, intercostals, etc. that are bolted together. I am modeling the vessel with 2D, first order elements and am modeling all fasteners and fastener holes. The problem that I run into is that the 2D automesher (including midsurface mesher) performs one of three operations: Failed surface mesh Meshes only around the holes (this is when I specify washers in the parameter/criteria files) Meshes over holes/cutouts that are below a certain diameter I've reworked and modified all parameters and criteria that I feel are relevant and even those that I feel are irrelevant. Further, when I perform topological cleanup and have the preprocessor locate and tag holes, it tags all holes except for those above a certain diameter (so Hypermesh is treating the larger and smaller cutouts differently). No matter what, I cannot mesh this structure and the direction that I feel I am taking now is non-intuitive and quite frankly arbitrary. Any guidance would be appreciated.
Hi friends, I have been using HM13, for a while. and I use one option a lot. That is Mid surface mesh from Create>Mesh>Mid Surface however I can't be able to put washers on the surface holes with correct diameter. Can anyone please help by telling , how to set parametric file such that I could get a good mesh flow and washers with the size 3.25mm and the average element size of 6mm. Thanks in advance