Search the Community
Showing results for tags 'optisrtuct'.
Found 2 results
Dear, I did a sweep calculation for a Degas Bottle, the frequency range is from 15Hz to 100Hz, acceleration level is 3g, when I got the response stress after the model frequency simulation, I outputted the stress tensor of the most critical element, but I found there are 12 stress tensor in the pch file, so how the hyperview use these tensor to get the plot stress? I could not find the way. Meanwhile, how the Optistruct calculate the damage based on the response stress, I mean how to calculate the cycles at interested frequency, I know the help document, but it doesn't tell too much. Thanks a lot! 20191202_GWM_B30_Degas_Bottle_LT_V5_Opt.pch