Search the Community
Showing results for tags 'pipe'.
Found 3 results
Dear Sirs, I'm trying to solve the pipe stress analysis according to the example ASME B 31.3 appendix S Fig.301.1, shown in below URL. LINK: ASME B31.3 pipe analysis example (page 21 & 22) I made the most of the pipe model except the pipe support at the node No.20. No.20 support is the constraint of vertical (Y-axis) movement of the pipe, so firstly I made the SPC with dof of "13456" aroud the pipe, but the analysis result showed unexpected movement. My SPC is fixing the vertical movement of "node on pipe surface", but I have to made is fixing vertical movement of all pipe elements passing through at the node 20. Therefore I have to made some constraint at the node No. 20 in global coordinates, not at the node on the pipe surface. Please refer to the attached .hm model. I assume this is non-linear analysis, but I have'nt done such analysis so I dont know what to do. I would appreciate any advice. Thank you in advance. Nonlinear.hm
Hi All, I have set up a model of a pipe section and tried to subject it to torsion. The analysis completes but I have some unexpected results. I would expect the stress to be circumferential rather than axial. Have I set up the model incorrectly? https://www.dropbox.com/sh/rz0mgw3t1h91axq/AACnBNA5HjrX8AGIwFcpbQo3a?dl=0 Thank you Luke
Hi, I am using hypermesh to generate CFD tetramesh and boundary layer to model a flow into pipes. I am first working on a simple pipe with an inlet and an outlet. I am using the cfd tetra mesh panel to generate the boundary layer and the tetramesh core. The boundary layer obtained is good for the first couple layers but the elements start to skew at some point which result in a very bad boundary layer mesh. This is extremely disappointing since this is one of the simplest case I can think of. I am planning to use the cfd mesher for a much complex piping case and this kind of mesh is not acceptable. Please help me with this issue. I used hypermesh 12.0.117. I attached a screenshot of the parameters used for the boundary layer. I also tried several other combination of the parameters. I also tried selecting float or fixed boundary layer without success. I also attached screenshots of the resulting elements to illustrate the problem. I also attach a .txt file containing the model of the pipe. (just change de extension to .fem and import it in hypermesh, I had to change extension otherwise the upload was not authorized). The pipe and inlet/outlet components are used as 2d input mesh for the boundary layer mesh generation. Thanks in advance for your help, I really need to make this work! cfd_tetramesh_BL_bug_example.txt