Jump to content
Rahul Ponginan

FAQ 6: How to contour results by configuration (1D, 2D or 3D)?

Recommended Posts

In HyperView,

On contour panel click the yellow color selector (components/element). A new window will pop-up “extended entity selection”. In that click By config and choose the element configuration type (for 2D: QUAD4/QUAD8)
699ot-Img_1.jpg

Share this post


Link to post
Share on other sites

 Have you prepared deck in Hypermesh Ansys interface?In Hypermesh Optistruct interface in Loadstep we set the type to all which writes all stresses.

 

Regards

Rahul R 

Share this post


Link to post
Share on other sites
On 9/10/2014 at 11:50 AM, Rahul Ponginan said:

In HyperView,

On contour panel click the yellow color selector (components/element). A new window will pop-up “extended entity selection”. In that click By config and choose the element configuration type (for 2D: QUAD4/QUAD8)
699ot-Img_1.jpg

Sir contour panel have different values of results for von mises stress or any result type. There are number of results get obtain for same element by changing averaging method, layer and coordinate system. 

 

Can you tell which combination I decide to get better result

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...