Jump to content
Sign in to follow this  

workshop 4 Blower – Sliding Mesh

Recommended Posts


any one can tell me in detail how to do this process below

i’m stuck in AcuSolve workshop 4 Blower – Sliding Mesh


I have a problem every i finishing runing acusolve transient analysis, can't open the result in AcuFieldView, always error to open it




Share this post

Link to post
Share on other sites

This "manual" step was necessary prior to AcuSolve 12.0. This is simplified to a great extent.


Use AcuConsole > Tools > Project Solution.

Select the .Log file from previous workshop. See screenshot.



Second issue with AcuFieldView

This typically happens in 12.0 when the initial conditions (time = time_step = 0) is written.  This issue has been fixed in HyperWorks 13.0.


If you want a solution with HW 12.0 then, couple of options

1. You can remove the initial conditions output set through acuDmg (or Tools > Disk Management - from AcuConsole) - expand the problem name and run number - then nodal output and delete the time step 0 set.

2. rerun the problem but first un-check the Write Initial Conditions in the Nodal Output setup.


3. Use AcuConsole > AcuOut > Output format = FieldView ( select other options appropriately).





Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Create New...