Jump to content
ggntju

How to make perfect square elements in solid map

Recommended Posts

Here is the problem, I have a curved surface, after meshing and the element offset, the layer is generated. Then use the solid map command to generate the solid elements, the destination surface is a surface below the layer. After above done, as can be seen, the elements on the bottom place are not perfect squares which do not satisfy the requirement. So, how can I make the perfect square elements when I do this?

Offset_by _face.png

xyz.PNG

bottom.PNG

Share this post


Link to post
Share on other sites

Hi,

Because of curved surface you got such pattern in bottom face.I feel this mesh is very good to carry out analysis.

Not possible to get perfect square element unless you have similar face on both side.

 

Regards

Rahul R

 

Share this post


Link to post
Share on other sites
20 hours ago, Rahul R said:

Hi,

Because of curved surface you got such pattern in bottom face.I feel this mesh is very good to carry out analysis.

Not possible to get perfect square element unless you have similar face on both side.

 

Regards

Rahul R

 

Hi, 

This is just an example of what I am trying to do, the object of what I am going to mesh is one part of a plain woven composite material, so, it requires that the RVE must be periodic , that's why I want it to be perfect squares.

Thanks for your interest

Guannan

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...