Jump to content
Sign in to follow this  
VisSim Forum Archives

How can I look at the frequency spectrum of a portion of my data

Recommended Posts

Submitted by Anders89 on Wed, 10/26/2011 - 19:11.

Good question Joe. There are a couple ways to skin this cat:

  • The easiest way is to use a plot block, right click to configure, check Frequency Domain and Log Y, then select Axis tab, under Retrace Options set Start Time: to 15,End Time: to 60, and Interval: to 45.
  • Another way is to use a triggered plot block: right click to configure, check Frequency Domain and Log Y and External Trigger. Then use a > block to compare a ramp to 15 and connect it to the trigger pin on the plot.
  • Another way is to use a triggered buffer block and activate the trigger during the interval you want to capture. Then use the PSD (Power Spectral Density) block into a plot.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...