Jump to content
Sign in to follow this  
Matthias Goelke

How WinProp can be used for the interference analysis between different RF systems?

Recommended Posts

The computation of the radio coverage in WinProp can be done in a first step for each RF system (typically each RF system use its own frequency band).

Based on assumptions how much power will be radiated from the Tx antennas into the other frequency bands (and how the reception of the other frequency bands will be attenuated on the receiving end) in terms of an adjacent channel leakage ratio (ACLR) it is then possible to post-process these radio coverage plots for the individual RF systems to determine the interference situation.

In a WinProp network planning project (e.g. for LTE or WLAN) generally only the co-channel interference is computed, while the adjacent channel interference is neglected.

This means for the determination of the interference on a specific frequency band (RF system) a project with the Tx antennas for all the considered RF systems can be defined and then the Tx power for the Tx antennas of the other RF systems can be reduced by the above mentioned ACLR (which needs to be derived outside of WinProp).

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...