Jump to content
muthu62

No Displacement / Stress Result after Simulation - Optistruct

Recommended Posts

Hi Everyone, 

 

I am working with Optistruct for my Linear/Static Analysis, I am doing Topology Optimization in my model but before I wanted to check whether my model is working regarding with displacement or stress result for my BCs. but after analysis result it shows nothing every displacement result is zero and no change. Can anyone take a look into my model whats wrong or what change I have to make. I used Hex mesh, with 4 Loadcases and one constraint. I have attached my model for the expect reference. It would be much apprieciated if i get any positive response. Thank you in advance.

 

Regards,

Muthu.

 

Share this post


Link to post
Share on other sites
Guest

Hi Muthu,

 

You have applied loads and Bcs on temp nodes. Delete temp nodes and create loads and BCs again.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...