Jump to content

Recommended Posts

Dir Sir or Madame

I have a few question regarding the tool deflection.

- Is it possible to perform a transient tool deflection in HyperXtrude/C2E ?

- If a calculate the coupled solution in C2E, do I also get the computed deformation of the Tool and the temperature distribution of the tool?

 

Thank you in advance

kind regards

 

Chiara

 

Share this post


Link to post
Share on other sites
  • Is it possible to perform a transient tool deflection in HyperXtrude/C2E ? ==> No. Only steady state is supported. You have to use the older approach of Coupled analysis in which you have to mesh WP and tool in one model and run the coupled analysis. This is supported in the older interface. 
  • f a calculate the coupled solution in C2E
    • It only has deformation. Temperature mapping is planned for future release and not available today.

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...