Jump to content
no name

Design a magnetic based coil using FEKO

Recommended Posts

Hi

Good day,

 

I would like to start with creating two different magnetic based coils as Transmitting coil (TC) and Receiving coil (RC), to measure the Z impedance values changes with respect to the movement of TC around RC.

Following are the configuration which I would like to proceed,

 

Transmitting Coil:

L

67 uH

Q

22

Ccalc

24.19 nf

-

-

F

125khz



Receiving Coil:

Coil Configuration

L

728.73 uH

Q

53.24

R

15kohm

Ccalc

2.224nf

F

125khz

-

-



The Receiving Coil (RC) resonated at a frequency of 125kHz and diameter of 7cm. Transmitting coil (TC) dimension is 9 x 9 x 9 mm^3.

Datasheet of RC as: https://www.rfsolutions.co.uk/downloads/1457021091DS-ANT-125K.pdf

Initially, the RC and TC will be 3cm away from each other on z axis. The Impedance( |Z| )  value can be measured with respect to the movement of TC on x-axis/y-axis.

-> The RC: loop antenna actual dimension, the copper wire diameter, number of turn, the diameter. (the details of the coil determine the inductance value)

For RC:
0.236mm diameter (34 swg) Enamelled Cu wire.
Diameter Antenna: 7cm internal ,
Number of turns: 67 turns
Inductance: 700uH
Quality Factor (Q): 17


For TC:
Inductance: 67 uH
Quality Factor (Q): 22
Capacitor: 24.19 nf
Frequency (F)    125 kHz
Number of turns: 52
Diameter: 8mm



-> Matching circuit details.

Matching circuit For RC : C = 2.3159nF  (Formula:F=1/2π √LC)
Matching circuit For TC : C= 24.19nF    (Formula:F=1/2π √LC)

 

kindly can you suggest me the step or user manual for me to start on to this project.

 

Looking forward to hearing your comments on it,

Regards

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...