Jump to content

Factor of Safety lower than required

Recommended Posts


I am currently working on a project for my Thesis and am using Inspire to optimize gears. The attached pic is a screenshot of an optimization where the goal was to minimize mass but keep a SF of 2. The analyzed solution does have a minimal SF of 0.9 though. Why does Inspire not just keep more mass at the place where the SF is too low?




Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...