Jump to content
Sign in to follow this  
freedbr2014

Error on Pressure Loading when using Optimization Solver

Recommended Posts

Hello,

I am currently in the learning/certification course called intermediate hypermesh examination.  I am on the last exercise where you set up and analyze a quarter of a submarine hull.  I followed the steps in the exercise file to a tee and yet when I run the solver, it gives me a result box in the analysis box.  However, there is no results button at the bottom of the dialog box with which I can analyze the results.  Is there any way to fix this issue?

 

The goal of this exercise is to analyze the pressure load by hydrostatic pressure on the outside of a submarine hull.  I need the answers to the stresses and displacements of the file to finish the final quiz and get my certification.  Please let me know if this is a common problem or there is somewhere I may have gone wrong.

 

Thanks!

Share this post


Link to post
Share on other sites
Sign in to follow this  

×
×
  • Create New...