Jump to content
Isshaan Arora

Error in Acu Console

Recommended Posts

It will be very helpful to me if some one can  resolve this problem which occurs while solving the iterations.

 

 

Error;

 *** Error from fLesGetHbrgEig <40>
acuRun: *** ERROR: error occurred executing acuSolve

 

 

 

Share this post


Link to post
Share on other sites

The solution is starting to go 'bad' around time step 50, then the errors accumulate and eventually the job stops.  This appears to be one inlet, one outlet, and a wall.  What type of analysis is this?  What max velocity do you expect?  Do you expect transonic/supersonic flow?  Is there reverse flow at the outlet?  Can you post an image or two of the simulation model, with an explanation of the behavior you expect?

Share this post


Link to post
Share on other sites

I also see there are only 57 thousand nodes in the model.  Does the model behave better with more mesh?  Maybe some images of the mesh would also be useful.  You could also contact your local Altair support.

Share this post


Link to post
Share on other sites

×
×
  • Create New...