Jump to content

Recommended Posts

Sorry.I'm confused about how to  connect two components,leading to problems below.

And i attach the hm file,could you help me check or correct it to run it?

Thanks! 

 

Messages for the job:

 
 *** ERROR # 312 ***
 In static load case 1 
 the compliance is negative or large -1.37409e+011.
 Optimization/buckling analysis cannot be performed.
 due to possible rigid body mode.
 FEASIBLE DESIGN (ALL CONSTRAINTS SATISFIED).
  

1.hm

Share this post


Link to post
Share on other sites

Elements of component 1 and component 2 are not connected.Please ensure connectivity and then, have design and nondesign region for optimization.

Share this post


Link to post
Share on other sites
On 1/3/2019 at 3:41 PM, Rahul R said:

Elements of component 1 and component 2 are not connected.Please ensure connectivity and then, have design and nondesign region for optimization.

sorry

I have tried to use the rbe2 to connect design and nodesign component, but the error still occurs.

I am not sure whether i ues the rbe2 right.

could you help me check the model?

1.hm

Share this post


Link to post
Share on other sites

Still there is no connectivity in the model.Do you have access for Altair SolidThiking Inspire? Setup for analysis and optimization can be easily done in Inspire.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...