Jump to content
mdrehmer

Optistruct vs Abaqus - Max principal stresses

Recommended Posts

My question is, what is the differences between the stress components in Optistruct and Abaqus? I mean, what is the difference between P1(major) - Optistruct and Max principal - Abaqus? The same analogy to P1(minor) and Min Principal.

I ran a simulation in both softwares with same mesh and same parameters to compare, and notice that as P1(major) and Max principal(Abaqus) values are very close, but the P1(minor) and min Principal(Abaqus) is very different!

Some details: It is a shell element analysis, and I set for stress calculation Gauss as location for optistruct and Integration point for Abaqus.

 

Thanks in advance!

 

Share this post


Link to post
Share on other sites

Yes it should be the same, but this is the problem. I got the same results for P1(major) and Max Principal, but different results for P3(minor) and Min Principal.

At time, the Mises results were equivalent in my comparison between abaqus and optistruct.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...