Paulo Araujo 1 Report post Posted October 21, 2019 There is a way to investigate the incidence of hot tearing on Inspire Cast? There is a result in the filling process in which we could investigate it? Quote Share this post Link to post Share on other sites
Pau 1 Report post Posted October 23, 2019 Hello Paulo, Hot tearing is a failure produced because of residual stresses during the solidification. Currently we can't predict this defect but we are working on a thermo-mechanical analysis that will allow us to postprocess hot tearing. This is scheduled for 2020.X Best Regards Quote Share this post Link to post Share on other sites
Paulo Araujo 1 Report post Posted October 23, 2019 Thank you Pau for your reply. I'll keep waiting for this resource, I have faced prospects that asked about this for Inspire Cast. Quote Share this post Link to post Share on other sites
