Jump to content
Sign in to follow this  

HyperMesh 2019 - Represent a fixed constraint that moves upon an acceleration load

Recommended Posts



I am running into a problem with a modal transient dynamic analysis: I am simulating a tower that is fixed-connected to a structural shake table, where the shake table is subject to an acceleration load...and I can't run the analysis.


My excitation and SPCs are coincident - this is the problem, but I can't figure out how to simulate a fixed constraint that is moving - the tower is fixed-connected to the base plate, and the base plate is excited by the acceleration load. The acceleration load gets transferred to the rest of the tower:








Does anybody know how to model this scenario correctly in HyperMesh or know how to tell HyperMesh to transfer the acceleration load from the base plate to the rest of the tower? I have gone through the modal transient dynamic analysis and have everything else set up - its just the excitation and SPC. The tutorial presented an example where the excitation and the SPCs were not at the same location. Thanks again for your help!

Edited by MaL2K16
Accidentally closed out of the text editor before all the information was put on

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Create New...