Jump to content
zainab

Problem in solving an induction motor

Recommended Posts

Hi dears,

I am a master student, i made my project induction motor with altair flux 12.2 and after solving the torque is very low and appear this warning showing below 

please your helping 

thanks.

image.jpeg

Share this post


Link to post
Share on other sites

Hi Zainab,

You have a convergence error. Since the numeric method is not converging, reliability of your results (if any) is not guaranteed.

Please, check your inputs, your mesh and your simulation time steps, since these are the key factors that can affect convergence.

For further helps, additional information about the problem will be needed. In that case, you can post your project in order I can check it.

I also advise you to use last software version, i.e., Flux 2019.1. You will enjoy more functionalities that may be useful for your master thesis.

Best regards,

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...