Jump to content
Balaji Viswanadh G

Warning Messages in Flux 3D Transient Magnetic Simulation

Recommended Posts

I have been receiving the following warning messages towards the end of my 3D transient magnetic simulations. I don't know what to make out of these messages.

Would anyone please kindly advise how to decode these and understand how these effect my simulation results.

 

Have a great day

Balaji

Warning_Messages_1.png

Warning_Messages_2.png

Share this post


Link to post
Share on other sites

Hi,

it a warning or a error message. because if it an error message , this means that the solving of the project is stoped.

Can you share the Flux project?

 

Best regards.

Share this post


Link to post
Share on other sites

@Abdessamed , I believe these are warnings. If you notice the name at the top of the window in my snapshots it says 'Warning'. Also these came after all time steps of the magnetic transient simulation are completely run. I could view the iso plots, 2D curves for all time steps without any problem. So that means the simulation did not stop in between.

 

Unfortunately, I cannot share my file due to restrictions. However, I could create a dummy project run it and see if I get these warnings. If I get the warnings again,  I can share the project with you.

 

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...