Jump to content
Jeugarcon

Strange Mesh problem in Split Hopkinson Bar modelling

Recommended Posts

Hello,

 

I'm doing Split Hopkinson Bar simulation with Radioss, as depicted below in Fig. 1, I refine the mesh in the middle of the incident bar in order to use them as strain gauge to measure strain signals. But when I conduct the simulation, the strain propagation stops and reflects when it spreads to the refined mesh(Fig.2). And the coarse elements pass through the refined elements(Fig.3).

However, the strain can spread to the end of the incident bar when I mesh the bar with the same coarse elements.

 

It's so strange because I only refine a small part of the bar mesh, in order to measure the precise strain signal (I can't refine all the mesh because of the calculation efficiency). Could someone figure out where the problem is? Any help would be appreciated.

 

Best

 

image.png.6b3d3f2226b3b660916f3a6906a6484a.png

                                                                           Fig. 1

image.png.9488817f3d5c408697de16f75306008f.png

                                                                     Fig. 2

image.png.f8a5ca735a3614a76079219635de8169.png

                                           Fig. 3

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...