Jump to content

Recommended Posts

Hi, I am using motionview to analyse my motorcycle's chassis while going on a road bump. I converted the chassis into a flex-body, and created a jack for the front wheel. I constrained the jack by a translational joint and also included the Bistop function. Under displacement I gave an expression, 50*sin(2*PI*TIME). My simulation ran without any error however, my travel was large. I wanted a 50mm travel but I'm not sure about the unit of this simulation. Could anyone please help me clarify this

Share this post


Link to post
Share on other sites

to get a 50 mm total travel with that sine function, you need to divide 50/2.  Amplitude of the sine function is not the peak to peak amplitude, it's half.

Share this post


Link to post
Share on other sites

×
×
  • Create New...