Jump to content
Toon

Particle tracing and particle concentration

Recommended Posts

Hi all,

 

I have a question on particle tracing. I want to set up a cfd simulation where an exhaust emits particles. I want to trace these (finite mass) particles and determine the particle concentrations at certain areas. As a bonus it would be nice if I could check the particles which are deposited on a surface near the exhaust.

I want to perform the cfd solution with acusolve while the particle tracing will be done with acutrace. Are the predescribed aspects possible within acusolve and acutrace software?

 

Looking forward to your replies

 

Toon

Share this post


Link to post
Share on other sites

Yes it would be possible to particle tracing using AcuTrace for you application. 

You might want to contact your local Altair Support in case AcuTrace setup gets tricky. 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
You are posting as a guest. If you have an account, please sign in.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...